Turning Archive 2006

Subject:
Quick change handle in picture 2 *LINK*

Leo Van Der Loo
>I should have mentioned with the pic's the extra narrow cutoff tool made of a metal hacksaw blade, works very well with small turnings.
Also the one handle shown in picture 1 with the small chuck is shown in picture 2 with a bent scraping tool, I have a short screw gun shaft in that handle, and can exchange 1/4" bits or other (like the chuck or allan wrench tools) by just pulling one out and inserting another, the tools go in 2" for a good fit.

Have fun and take care
Leo Van Der Loo

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081