Turning Archive 2006

Subject:
Plans for tilting tailstock 3520

Earl Eyre
>Awhile back I downloaded or saw in a magazine plans for a platform that bolted on the end of a 3520. You could slide the tailstock onto it and then tilt it out of the way. I'm ready to build it and lost the plans. I've looked and searched every site I can think of to no avail. I think I can re-invent it but I would much rather go with a proven design. Can any of you point me to it?

Earl

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081