Turning Archive 2008

Subject:
Re: Pen Drilling Vise & Assembly

eaglesc
>There is another method that exempl;ifies the KISS technique.
I saw this along time ago, after I made my "V" block.
Stand 2 pieces of 2X4 stock and hinge together on the end grain.
Clamp shut and drill where the two abut with a 1/2 inch bit.
Mark the table where the 2x's lay when you drill them.
The result will be a "block that is already custom drilled to compensate for any irregularities of the table versus the Quill.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081