Turning Archive 2007

Subject:
Re: Am I the only one?
Response To:
Re: Am I the only one? ()

Barry Irby
>Elliot, I have been playing with my Jamieson Captive bar system. I tried your idea on the first vessel I use it on and it worked great. I tried it with the tool dead center vertically and a 3/16" scraper. Could not make it work going forward. Switched to the Hunter cutter and ran the lathe backwards and it sniped it right off. Since that cutter won't cut going straight ahead, I just press it to the bottom to the rear of the nub and swung it forward. Worked great. Thanks.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081