Turning Archive 2007

Subject:
Yup, yup, and yup that one twice!

Steve Kubien
>Been there, felt the pain and the shame. Finally cut something the correct length, but out of square. Cut the dado, on the wrong end. Drilled pilots for #8 screws, only to find I am using #6. The sandpaper one is a classic. I do that every couple of months!

Thanks for the giggle.

Steve Kubien

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081