Turning Archive 2007

Subject:
Re: Don, use your hand.
Response To:
Swan neck gouge question ()

Allen Neighbors
>I've made three different sizes of swan necked tool shafts. Just hold your hand up, cup the hand, and use your arm to draw the shaft. Lay it on your bench, and draw one line, following the curve of your and wrist. Then make a couple of different variations of it. Clear as mud?
I've made two 1/2" shafts and one 5/8".

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081