Turning Archive 2006

Subject:
Re: Pneumatic Air Hammer Choices

John Lucas
>Chris I use a dremel engraver. I remove the pointed tip and replace it with a rounded over bit, it's 1/8" so i just used an old drill bit shank. I used to freehand draw patterns probably in the same way Greame uses his tool. You can get them for around $19.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081