Turning Archive 2006

Subject:
Re: sharpening a Glaser 5/8 bowl gouge

Greg in Oshkosh
>the first time I had to use the Wolverine to sharpen my ellsworth I found that I couldn't get it set correctly. That's because the ellsworth jig has the pivot point at the back and the wolverine at the front. I had to extent the gouge out about 3" not 1.75. You may have to change that 1.75" stick out for your glaser as well as the pivot angle and the holder. Good luck

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081