Turning Archive 2005

Subject:
Re: I can't read...
Response To:
I can't read... ()

Brian Hahn in SW Wisconsin
>I think your question is answered in the instructions on page 32. Step 58 calls for the diamond block to be 1.897 inches long. Subtracting that from the 2.012 segment length gives 0.115 for the walnut thickness, not the 0.125 printed in the text.

Hope that helps,
Brian

Messages In This Thread

I can't read...
Re: I can't read...
Re: I can't read...
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081