Turning Archive 2005

Subject:
Re: Tool gloat #2
Response To:
Re: Tool gloat #2 ()

John Trant (Baltimore/DC corridor)
>Use it just like you would if it were a bowl gouge. For those that may not know, the bit is a ball nose end mill.

John

Messages In This Thread

Tool gloat #2 *PIC*
Re: Tool gloat #2
Re: Tool gloat #2
Re: Tool gloat #2
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081