Turning Archive 2005

Subject:
Re: A little work
Response To:
A little work *PIC* ()

Greg in Oshkosh
>The shape of the hollow form is good but it doesn't go with the shape of the base. I understand the situation under which you created this piece but I might have filled the inclusion with epoxy or CA and cut it off. Could you cut off the base and then fill the remaining inclusion with epoxy. The put it back on the lathe between centers and cut the bottom?? I know it's hard to see how scary the situation is from the picture.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081