Turning Archive

Subject:
Re: drilling 1" holes
Response To:
drilling 1" holes ()

jake niedling
I'm thinking that the ends are not 90 degrees to the 1" hole. I took a look at the item you are making from PSI. If the ends are not cut perpendicular to the hole, then when you assemble the parts, it will push the opposite end of the shaft off center in the hole. Just my 2 cents.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081