Turning Archive

Subject:
Re: drilling 1" holes
Response To:
drilling 1" holes ()

Paul Grenier
How are you drilling the hole? What type of drill bit are you using? I always use a Forstner type bit.

Are you drilling the hole while the blank is mounted on the lathe in a 4 jaw chuck? i would think that it would be very difficult to drill an off center hole this way.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081