Turning Archive
Subject:
Re: Routers and shapers scare the $#% out of meResponse To:
Routers and shapers scare the $#% out of me () keith tompkins
Steve, I had a big three-wing shaper cutter explode while I was using it. 1.25" spindle size, the cutter was about eight pounds. Pieces went through the block wall ahead of me, cracking it top to bottom. It then proceded to go through the exterior wall as well. If it went my direction, it would have cut me in half. But, what I'm really afraid of is heights!
Messages In This Thread
- ***SURVEY: THE IDES OF JANUARY (+5)*** *PIC*
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Noise and Dust
- Caliper (divider)
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Re: ***SURVEY: THE IDES OF JANUARY (+5)*** *PIC*
- Routers and shapers scare the $#% out of me
- Re: Routers and shapers scare the $#% out of me
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Unisaw
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
- Noise and Dust
- Re: ***SURVEY: THE IDES OF JANUARY (+5)***
