Hand Tools Archive 2008

Subject:
Re: What to do about stripped threads?
Response To:
What to do about stripped threads? ()

Jim DeLaney, Austintown, Ohio
>Marv's comment about metrics brings up a good poing. ~20tpi would be a metric pitch of 1.25 - or one turn in 1.25mm. You may be able to find a metric nut that you can solder or epoxy into the stripped part.

Jim D.

© 1998 - 2012 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081