Hand Tools Archive 2008

Subject:
Re: how flat is flat enough
Response To:
how flat is flat enough ()

Alan DuBoff
>** Caution - entering SARCASM zone **

I would go out and buy the best machinist straight edge, just to make sure your work is at least that flat until it continues to acclimate.:-/

** You are now exiting the SARCASM zone **

© 1998 - 2012 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081