Hand Tools Archive

Subject:
Re: Entry hall table for a niece: Part 3

Derek Cohen (in Perth, Australia)
Hi Oskar

Thanks for describing your experiences.

You are spot on when you say “all in”. In the current build it is not possible to undercut the mitres to make them fit. The reason is the inside edge on the model calls for a bevel/mitre all the way around. I plan to do a slight cove. In any event, this open up the mitre from the inside, and any undercutting would show.

Regards from Perth

Derek

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081