Hand Tools Archive
Subject:
It sure as hell ain't from heatResponse To:
Re: Fear of heat () Bill Tindall, E.Tn.
My chisels are made from CPM 3V that was tempered at 1000 degrees F. Even I would notice an edge getting this hot during grinding. But then I don't grind to the edge; yet another reason your speculation misses the mark no matter the steel.
Messages In This Thread
- Tormek: getting old wheel off?
- Re: Tormek: getting old wheel off?
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Fear of heat- not an issue
- Re: Fear of heat
- Re: Fear of heat
- It sure as hell ain't from heat
- Re: Fear of heat- not an issue
- Re: Fear of heat- not an issue
- Search surface grinder wheels, Type 1 *NM*
- You have identified the problem
- I did find this I wheel
- Search surface grinder wheels, Type 1 *NM*
- Re: Fear of heat- not an issue *LINK*
- Re: Fear of heat
- Re: Tormek: getting old wheel off
- Re: Fear of heat
- Fear of heat- not an issue
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off?
- Re: Tormek: getting old wheel off?
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off?
