Hand Tools Archive
Subject:
Re: Tormek: getting old wheel offResponse To:
Re: Tormek: getting old wheel off () david weaver
glad to hear that the outcome was good, Wiley.
The wheels are still usable despite looking like an exit hole in ballistic gelatin. I doubt you'll have any incentive to use them going forward now that you have CBN.
Your CBN will lose a little bit of its snort (maybe) in the near future, but will then settle in. Mine lost its brashness in a month or two of intermittent use, but I can't say (on a high speed grinder) that I've noticed any real degradation since.
Messages In This Thread
- Tormek: getting old wheel off?
- Re: Tormek: getting old wheel off?
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Fear of heat- not an issue
- Re: Fear of heat
- Re: Fear of heat- not an issue
- Re: Fear of heat- not an issue
- Search surface grinder wheels, Type 1 *NM*
- You have identified the problem
- I did find this I wheel
- Search surface grinder wheels, Type 1 *NM*
- Re: Fear of heat- not an issue *LINK*
- Re: Fear of heat- not an issue
- Re: Tormek: getting old wheel off
- Re: Fear of heat
- Fear of heat- not an issue
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off?
- Re: Tormek: getting old wheel off?
- Re: Tormek: getting old wheel off
- Re: Tormek: getting old wheel off?