Hand Tools Archive
Subject:
Re: How Are You Cleaning The CBN Wheel . . .Response To:
How Are You Cleaning The CBN Wheel . . . () Derek Cohen (in Perth, Australia)
Hi Tom
I have avoided grinding mild steel, but am about to grind unhardened O1 (as I have some blades to make). I have done one so far and the CBN surface was fine. If the wheel done gum up, I plan to grind hardened steel to clean it.
Regards from Perth
Derek
Messages In This Thread
- flattening Waterstones- shapton pro
- Another possibility presents itself......
- What a great thread this has been.....
- Re: What a great thread this has been.....
- a little bit the Indian and a little bit arrow
- which side to use?
- Quick and dirty summary:
- Atoma - $64
- Re: Quick and dirty summary:
- Re: flattening Waterstones- shapton pro
- A different perspective *LINK*
- Re: A different perspective
- Re: A different perspective
- My thoughts
- CBN and grit
- How Are You Cleaning The CBN Wheel . . .
- Re: How Are You Cleaning The CBN Wheel . . .
- Re: How Are You Cleaning The CBN Wheel . . .
- Re: How Are You Cleaning The CBN Wheel . . .
- Re: How Are You Cleaning The CBN Wheel . . .
- Re: How Are You Cleaning The CBN Wheel . . .
- The flat wheel surface - or not..
- Re: My thoughts
- Re: My thoughts
- How Are You Cleaning The CBN Wheel . . .
- My Opinion...
- My thoughts
- Re: A different perspective
- Re: A different perspective
- lapping film?
- Re: flattening Waterstones- shapton pro
- Diamond plates......
- Flattening
- Re: flattening Waterstones- shapton pro
- Re: flattening Waterstones- shapton pro
- Re: flattening Waterstones- shapton pro
- What a great thread this has been.....
- Another possibility presents itself......