Hand Tools Archive
Joseph Piotrowski
it must be how i layout the dovetails but i'm finding myself in need a 3/8 inch chisel, which i don't have. i like my narex chisels but i would like to buy chisel with better manufacturing. i am so tired of spending my limited shop time flatting the back of tools. the last narex i purchased tool me 2 hours to flatten and even then it has as hollow spot way to close to the cutting edge. and no i don' t want a courser stone than i already have. i'd like a tool from a manufacturer that grinds there chisel flat. hollow ground like a Japanese chisel if fine if they are good enough to get flat in 10 mins.
the primary use for this tool is chopping dovetails. i'm open to big or small handcrafted manufactures.
if anything my sharpening skills have increased to the level where i can shave the hairs off my knuckles with no problems! manscaping, one chisel at a time
TIA
Messages In This Thread
- high end chisel recomendations?
- Re: high end chisel recomendations?
- Re: high end chisel recomendations?
- question
- Re: question
- Hey, wait a minute....
- You have a point on the steel but not the bread
- Re: You have a point on the steel but not the brea
- What the Pros use *PIC*
- Re: What the Pros use
- Re: What the Pros use
- Bill/Todd
- Re: Bill/Todd - 19th century tools...
- Re: Bill/Todd
- No room for improvement
- Re: Bill/Todd
- Re: What the Pros use
- Re: What the Pros use
- Bill/Todd
- Re: What the Pros use
- Re: What the Pros use
- Re: What the Pros use
- Re: What the Pros use
- Re: You have a point on the steel but not the brea
- Re: You have a point on the steel but not the brea
- Re: What the Pros use
- Re: You have a point on the steel but not the brea
- What the Pros use *PIC*
- Re: question
- You have a point on the steel but not the bread
- At a guess...
- Re: question
- Hey, wait a minute....
- Re: high end chisel recomendations?
- question
- I'm curious...
- Re: high end chisel recomendations?
- Two Cherry set up was not easy
- Japanese Chisels
- Lee Valley
- Re: high end chisel recomendations?
- Re: high end chisel recomendations?
- Re: high end chisel recomendations?
- Re: high end chisel recomendations?