Hand Tools Archive

Subject:
Re: 3/4 dado plane depth
Response To:
Re: 3/4 dado plane depth ()

steve voigt
Hi Ron, thanks for the info. Another useful data point.
I am sure no one sells the nickers, but they are not too hard to make. If you are up to heat-treating, a piece of O1 from Victornet, MSC, or anywhere else would suffice.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081