Hand Tools Archive
Subject:
Re: Chipbreaker gemetry *PIC*Response To:
Chipbreaker gemetry () Mark Hennebury
I posted these a couple of days ago on a previous thread,
The shavings wont choke if set like this, you can make this so tight that it will squeese the shaving a little , but as you say, it wont choke up.
45° bed and 34° bed
The higher the bed the tighter it gets and the more you have to file from the throat angle to open up the chip clearance.
Messages In This Thread
- Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- This is not quite the right answer..
- Re: Chipbreakers. It's now official.
- What Warren Said...
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- That was also my understanding and conclusion. *NM*
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- Chipbreaker gemetry
- Re: Chipbreaker gemetry *PIC*
- Re: Chipbreaker gemetry
- confirming this observation
- Re: Chipbreaker gemetry
- Re: Chipbreaker gemetry *PIC*
- Chipbreaker gemetry
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- (Message Deleted by Poster)
- This is not quite the right answer..
- Chris is an honest guy
- Re: Chipbreakers. It's now official.
- (Message Deleted by Poster)
- Damn! Now the price of chip breakers will go up
*NM*
- Thank you
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.
- (Message Deleted by Poster)
- Re: Chipbreakers. It's now official.
- Re: Chipbreakers. It's now official.

