Hand Tools Archive

Subject:
Re: Pretty darn good for a practice chair
Response To:
Re: Pretty darn good for a practice chair ()

Bruce, a MN Galoot
When I made that Moseresque chair, I found it necessary to make a jig to drill the spindle holes in the seat. The rail/arm was only 1-1/8" thick (oval shaped) but it had very little flexibility. It would be nigh until impossible to drill those holes by eye. Ya done good!

© 1998 - 2012 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081