Messages Archive

Subject:
Drill press, yes....tilting table, No

Barry Irby
I bought a DP with tilting table at a tool auction and got it home. It got such bad reviews I was unwilling to trade out my old Rockwell for it and not enough shop space to keep both. So I sold it and made $150 on the deal. I did keep the hold down clamps the guy had on it. My Rockwell is a floor mocel and will drill to the center of a 16" circle.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081