Messages Archive
William Duffield
You're quite welcome. I have several pictures as well, but they are scattered around on several threads in the hand tool forum, over a few years. Note that if you use 3/4" Acme thread hardware instead of the 3/4" UNC that I used, one or two dimensions will need to be adjusted, because the Acme thread nuts are larger. The hardware will also cost you at least twice as much, but still a small fraction of Benchcrafted hardware.
I'm afraid I'm not nearly as good (or at least as consistent) at documenting what I've built as Derek Cohen or Bill Tindall. I think what frustrates me most is the arcane methods we need to employ to shrink the pictures down to 100 K.
I haven't done it yet, but I have the hardware and other materials out in the shop to add a handle to each of the hand wheels, like the Benchcrafted add-ons, or the cast iron hand wheels on my milling table and cross slide vise. Maybe I'll get out in the shop tomorrow to experiment.
Messages In This Thread
- Utilitarian Moxon vise. *PIC*
- It dawned on me.....
- Re: Utilitarian Moxon vise. (added some clamps) *PIC*
- Clamps unnecessary,and, the last straw!
- I am bewildered by some of your repsonses
- It must be tough being.....
- Re: Clamps unnecessary,and, the last straw!
- Re: Clamps unnecessary,and, the last straw!
- Maybe clamps are necessary
- Re: Utilitarian Moxon vise. (added some clamps) *PIC*
- Re: Utilitarian Moxon vise. (added some clamps)
- Re: Utilitarian Moxon vise. (added some clamps)
- Re: Utilitarian Moxon vise. (added some clamps)
- Re: Utilitarian Moxon vise. (added some clamps)
- Re: Utilitarian Moxon vise. (added some clamps)
- Re: Utilitarian Moxon vise. (added some clamps)
- Re: Utilitarian Moxon vise. (added some clamps)
- Re: Utilitarian Moxon vise. (added some clamps)
- Looking good .. working great!
*NM*
- I am bewildered by some of your repsonses
- Re: Utilitarian Moxon vise.
- Re: Utilitarian Moxon vise.
- Re: Utilitarian Moxon vise.
- Re: Utilitarian Moxon vise. (added some clamps) *PIC*
- It dawned on me.....