Messages Archive

Subject:
Re: I built a small scale bench
Response To:
I built a small scale bench ()

Barry Irby
Giving that some thought. My shop is so small, If I am not using it, it's in the way. Very three dimensional. Top of planer serves as in feed or out feed for bandsaw. It's on wheels. wood going into planer starts over shop vac under bench and feeds out under wing of TS. Fence on jointer serves as support for work being cut on RAS. Etc.

But a very small roll around bench might be good.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081