Re: trading one problem for another

Messages Archive

Subject:

Response To:

Barry Irby
How about marking them and sawing the kerfs and then cutting off the ends with a chop saw or miter box? Not sure that's any better than chopping and fitting the tails and then cutting the ends, but maybe.....

Messages In This Thread

problems laying out, marking 135 degree dovetails *PIC*

Re: problems laying out, marking 135 degree doveta

working on that idea *NM*

Re: problems laying out, marking 135 degree doveta

trading one problem for another

Bill after this, you might as well slope the sides

Re: Bill after this, you might as well slope the s

Nobody puts baby in a corner! *NM*

Re: trading one problem for another

Thanks for posting these

Archive List Messages Live Forum

Return to Index Read Responses

0 wallclock secs ( 0.21 usr + 0.03 sys = 0.24 CPU)

PLEASE PATRONIZE OUR SPONSORS! SEE THEM ALL ON OUR MARKETPLACE PAGE

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081