Messages Archive

Subject:
Re: How to cut this
Response To:
Re: How to cut this ()

kruizen
Maybe make a plywood doughnut and shim an hot glue to the correct angle to establish the plane use a hand saw to cut off. Then use something to clean up the surface (low angle block plane, belt sander, router jig, ect.).

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081