Messages Archive

Subject:
trading one problem for another
Response To:
Countersink and use #8's? ()

Bill Tindall, E.Tn.
I still need to buy screws if I remill to #8, which I would rather not do. The #8's I bought (from Lee Valley?) are too poorly made to use. The screws even at #7 look out of place large in the hinge. I'll try McMaster Carr screws. thanks.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081