Messages Archive

Subject:
Re: Drill Driver acting up - recommendations?
Response To:
Drill Driver acting up - recommendations? ()

Ralph Lipeles
I had the same problem on my Dewalt 12V. I took off the covers and played with the parts until I could duplicate the problem. I found that one of the push-ons that was crimped to a wire going to the switch had a bad crimp. I squeezed it in Vise Grip and the problem went away.

Ralph Lipeles

© 1998 - 2012 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081